Optical Fiber Cable Tensile and Crush Tester
ISO 7500-1, EN 10002-2, ASTM E4, JIS B7721, ASTM E83, ISO 9513, and EN 10002-4
Tensile performance as per IEC-60794-1-2 Method E1
Crush (compression) as per IEC-60794-1-2 Method E3
This measuring method applies to optical fiber cables, which are tested at particular tensile strength in order to examine the behavior of the attenuation and the fiber elongation strain as a result of the load on a cable, simulating the conditions which may occur during installation and/or operation.
The TT-OFB-TC Series Optical Fiber Cable Tensile & Crush Tester comes in 100kN, 150kN and 200kN capacities.
Optical Fiber Cable Tensile & Crush Tester - TT-OFTC Series Technical Specifications
|Model & Specification||TT-OFTC Series|
|Load capacities||100kN，150kN, 200kN (other loads available upon request)|
|Deformation measuring accuracy||±0.5%|
|Displacement measuring accuracy||±0.3%|
1. Gauge length 1000mm
2. Measuring resolution is better than 10μm
3. Accuracy is better than ±0.5%.
|Crosshead travel||800 ～1100mm|
|Load Measurement Accuracy||±0.5% of reading to 1/100 of load weighing system capacity meets or exceeds the requirements of the following standards: ISO 7500-1, EN 10002-2, ASTM E4, JIS B7721|
|Strain Measurement Accuracy||±0.5% of reading to 1/50 of full scale with most ASTM E83 class B or ISO 9513 class 0.5 extensometers meets or exceeds ASTM E83, ISO 9513, and EN 10002-4|
|Speed Accuracy||Set speed＜0.05% Max. speed: ±1% Set speed ≥0.05% Max. speed:±0.5%|
|Position Measurement Accuracy||±0.01% of reading or 0.0001 mm, whichever is greater|
|Operating Temperature||0 to +38°C (+32 to +100°F)|
|Humidity Range||10% to 90% non-condensing|
|Power (kW)||220/240VAC, 50-60 Hz (other voltages, frequencies available upon request)|